In the deep groove ball bearing material why high temperature, high, and how to solve the problem?
The assembly of 1, our tight coupling belt or bad in a bad state. Here you can adjust the belt tension, proofread and verify the coupling to repair.
2, groove ball bearing and deep axis is too early or too lax instead. When too tight, re grinding, corresponding to loose, should be fitted to the shaft sleeve.
3, the motor deep groove ball bearing cover or both sides of the end of the assembly is not in good condition. Repair method is to end cover or deep groove ball bearing cover screw tightening screw, flat, loading and other measures.
4, it may also be deep groove ball bearing lubricating oil content is too small, appear impurities or oil ring stuck situation. In this case, refuel, replace the oil, or repair the oil ring.
5, deep groove ball bearing has been damaged, of course, this situation is rare, can be based on the general life of deep groove ball bearing to replace.
6, deep groove ball bearing with the end cover with too tight or too loose. Deep groove ball bearing processing room when too tight, too loose in the end cover steel sleeve.
7, deep groove ball bearing grease too little or too much or iron filings and other impurities. A common knowledge that requires knowledge is that the capacity of deep groove ball bearing grease does not exceed 70% of the total volume, and obvious magazine conditions can be replaced in time.
|
